304451 - Ceiling Mounted Wide-Band Panel Antenna. Recommended to replace dome antenna. Double coverage area and easy to install.
Select a location on the ceiling that you can access from above to run the antenna cable. Verify that your chosen location allows for the necessary separation between the Inside and Outside Antenna (see Signal Booster installation instructions for antenna separation requirements). Use the antenna as your template in your predetermined location. Note: Ensure that the cable connector location is NOT below a ceiling rafter. Drill a hole large enough to accommodate the dimension of the connector on the location you have marked for the cable. Hold the antenna to the ceiling and mark the locations for the screws and then drill a 3/16” hole and tap anchors into the pre-drilled screw holes. Attach the Signal Booster “Inside Antenna” cable to the connector on the Ceiling Mount Antenna. Place the antenna fl ush against the ceiling, and then screw the antenna into place (screws and anchors provided). Be careful not to over-tighten.
8.27 x 7.09 x 1.73 inches
21 x 18 x 4.39 cm
Built-In Ground Plane